Pro AV Catalog
Manufacturers
PRODUCT CATEGORIES
Matching Keywords
Model Numbers
Request Quote
All Products
Video Controlled Relay - BNC
Series:
Model: TX-VCR
- Detect Video Presence
- Detect Loss of Video
- Bridging or Terminated Operation
- Detection of NTSC or PAL Signals
- Dry-Contact Outputs
Product Info
Tech Specs
Related Products
Documents
Accessories
The TX-VCR is the ideal choice in installations where a control signal is needed based on the absence or presence of valid video signals. The unique power supply input allows the TX-VCR to be powered from a wide variety of existing ac or dc power sources. The TX-VCR has one video INPUT and a LOOP OUT video jack. The detection circuit bridges a 1V video line. The TX-VCR may be inserted in a video line with the loop-through video output feeding a terminated load. It may alternatively be installed at the end of a video line by installing a 75 ohm terminator to the LOOP OUT video jack. The terminator is supplied with the TX-VCR. Video detection is based on valid sync signals. The TX-VCR responds to valid NTSC or PAL sync while ignoring 50 Hz and 60 Hz hum and related induction artifacts. The TX-VCR is able to detect signals as weak as 0.5 V p-p. When a valid signal is detected, the relay contacts close. Both a normally-open and normally-closed contact are provided, permitting the module to be connected as a video-present detector or as a video-loss detector. The front-panel SYNC LED lights when valid video is being detected. If a local or remote loss of video audible alert is needed, the TX-VCR may be wired to an RDL BZR.
- Detect Video Presence
- Detect Loss of Video
- Bridging or Terminated Operation
- Detection of NTSC or PAL Signals
- Dry-Contact Outputs
- Operation from AC or DC Power
- Operating Temperature (Maximum): 131 F
- Operating Temperature (Minimum): 32 F
- Height: 1.40 in
- Width: 1.20 in
- Length: 3 inch
- Inputs: BNC, ground-referenced
- Input Level: 0.50 V p-p video to 1 V p-p video
- Outputs: LOOP OUT, BNC, ground-referenced (Output must be terminated with 75 ohm connected load or with 75 ohm terminator supplied)
- Control Output: N/O or N/C relay contacts
- Relay Contacts: Single-pole/double-throw
- Maximum Switching Power: 60 W (220 Vdc, 125 Vac, 2A)
- Power Requirement: 12 to 33 VDC or 12 to 24 Vac, @ 75mA
Datasheet for Video Controlled Relay - BNC
185974 kb
- Other
Request Quote
Thank you!
Someone will be in touch with you shortly.
Contact TRITECH Communications
close
TRITECH Communications
625 Locust Street, Suite 300
Garden City, NY 11530
USA
(631) 254-4500
www.tritechcomm.com
Contact in regards to this product:
Radio Design Labs
Model: TX-VCR
Request more information from a dealer near you
close
Request more information from a dealer near you